Glock Firearms banner
1 - 9 of 9 Posts

·
Premium Member
Joined
·
1,516 Posts
Fire 1 thousand rounds of ammo thru the gun and practice your sight alignment.
Clean the pistol, your ready to go!:)
 

·
Banned
Joined
·
1,810 Posts
The stock trigger isn't too bad but if you want a more consistent pull then you can go with a 3.5# connector matched up with an NY1 Trigger Spring. I took a full coil off of the spring that's inside the NY1 Plastic part and the trigger feels great to me now. Slightly firm but not too firm with a very clean break and an awesome reset.
 

·
Registered
Joined
·
7 Posts
A polished 3.5 connecter did wonders in my 17. I also polished the trigger bar at the point of contact to the connecter. I also replaced all my springs. It was 3.2 after I got it all done. There's a two pound connecter out there I think I might try if I don't stick to the Rocket connecter.

Good luck,
Raven42
 

·
أنا لست ارهابيا
Joined
·
75 Posts
The stock trigger isn't too bad but if you want a more consistent pull then you can go with a 3.5# connector matched up with an NY1 Trigger Spring. I took a full coil off of the spring that's inside the NY1 Plastic part and the trigger feels great to me now. Slightly firm but not too firm with a very clean break and an awesome reset.

+1 on the NY-1 and Minus or 3.5 connector.. feels very nice..
 

·
Premium Member
Joined
·
4,108 Posts
Fire 1 thousand rounds of ammo thru the gun and practice your sight alignment.
Clean the pistol, your ready to go!:)
+1










10 cl
 
1 - 9 of 9 Posts
Top