Glock Forum banner
1 - 1 of 1 Posts

· Glockin’ since 1993
Joined
·
51,436 Posts
You may have a timing issue. Is it shaving material off of the bullet coming out of the cylinder gap? I had issue with the cylinder not releasing. Had a repair center somewhat close and had it repaired free. I'd contact Smith & Wesson and see if you have a repair center near you. Or take it to a revolver smith.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top