Need glock magazine measurements

Discussion in 'Glock Forum' started by lexington, Jun 20, 2015.

  1. lexington

    lexington New Member

    2
    0
    Hello,

    I am hoping to do an engineering project 3d printing glock high capacity magazines. I was wondering if anyone has the measurements needed for a 3d model available already, or if someone was willing to bust out their calipers and take them for me? I am willing to share the files with the community once I complete them if anyone is interested.
     
  2. LT2108

    LT2108 Administrator Staff Member Admin Moderator Lifetime Supporting Member

    52,679
    1,304
    Ohio
    I don't know about your question, but.......Welcome to the forum

    If you have a minute, feel free to post an inteodu introduction, in the intro sub forum
     

  3. lexington

    lexington New Member

    2
    0
    Or, if someone already knows where to find a 3d model of a magazine, that would be even better.
     
  4. smooth1

    smooth1 Member

    34
    0
    High capacity or standard capacity?
     
  5. Silver-Bolt

    Silver-Bolt Well-Known Member

    If your intent is to end up with a functioning 3D printed mag you will need to have a factory mag in your hands. Far too many angles, radii, and tapers to measure with a set of calipers.
     
  6. Audioph1x

    Audioph1x Well-Known Member

    1,061
    41
    What state are you living in?