Glock Forum banner

Home Gunsmithing at it's finest!

4K views 14 replies 13 participants last post by  Kmurray96 
I've seen something like that. Someone put a ported barrel in a G19 that didn't have a ported slide. The dust cover was bent downward but it wasn't bad, he must've realized the problem after only a few rounds and stopped before it got too bad. I think he boiled the dust cover then bent it back and held it in place while it cooled, it came out looking fine.

That looks like the dust cover is just barely hanging on by the serial number plate.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top