Glock Firearms banner
1 - 10 of 10 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hey guys I bought my g19 and had the problem with the gun jamming I heard it was the spring. Anyone else have this problem or suggestions
 

·
Banned
Joined
·
14,133 Posts
Welcome to the Glock Forum TNglock1990 !!

Could you give us a little more detail... "gun jamming"

Failure to Extract...Failure to Feed...?
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
About every 100 rounds there will be a failure to extract I've had my gen 3 g27 for about 3 years never had a problem yet with over 2000 rounds through it
 

·
Banned
Joined
·
1,000 Posts
Welcome to the forum TNglock, Enjoy.
 

·
Registered
Joined
·
115 Posts
TNglock1990 said:
Hey guys I bought my g19 and had the problem with the gun jamming I heard it was the spring. Anyone else have this problem or suggestions
Last week i went to the Glock site, they where replacing springs on gen 4 guns because they where defective for free. Go check it out.
 

·
Banned
Joined
·
2,947 Posts
I really doubt it is the spring, the ejectors have had issues and depending on which one you have Glock will repair it for free.
 

·
Duct Tape, Alabama Chrome
Joined
·
1,672 Posts
Call Glock up with the serial and they can tell you real fast if its got old parts. If the ejector is stamped 336 its the old one with issues. If its a different number its probably fine.
 
1 - 10 of 10 Posts
Top