Glock Firearms banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
13,754 Posts
Discussion Starter · #1 ·
I was at a gun store I don't usually go to earlier today. I bought a holster for my gen.3 G-30, but before I paid I asked if I could try it on with one of the G-30's they had there. Then I asked if I could remove the slides on the G-30, and 29 they had in the case to compare the difference, or non-difference in the inner parts. I noticed both guns recoil spring assembles then mine. They looked similar, except around the large spring there was a metal casing that had cut outs were the large spring could be seen. Has anyone seen anything like this before.
 

·
Female Member
Joined
·
1,259 Posts
I know the glock20 and 21 are the same so I would assume the 29 and 30 would be the same as well
 

·
Premium Member
Joined
·
13,754 Posts
Discussion Starter · #3 ·
I went back and looked again, the 29 had the reinforced dual recoil spring, no the 30. Sorry for uninformed post.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top