Glock Firearms banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I dropped in a 3.5 lb. Ghost trigger into a G27 Gen 4 and started getting reset failures approximately every 15 to 20 cycles. I put the OEM part back and the problem went away. I read a lot of positive reviews for Ghost parts before I put it in. Has anyone had problems with Ghost stuff?
 

·
Banned
Joined
·
4,056 Posts
arsoninv said:
I dropped in a 3.5 lb. Ghost trigger into a G27 Gen 4 and started getting reset failures approximately every 15 to 20 cycles. I put the OEM part back and the problem went away. I read a lot of positive reviews for Ghost parts before I put it in. Has anyone had problems with Ghost stuff?
I had a similar problem, except for mine it was the spring underneath the sear. Once I disengaged the trigger safety, it would stay to the rear, basically rendering the gun safety-less. Once I replaced the ghost spring back with the OEM spring, it corrected itself.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top