Glock Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
Could one be built from Parts or usage of a Glock 17-22 Frame and Conversion Barrel & Magazine ? and were Glock 25 models ( Or other Doublestack .380 Glock Models ever sold in US ? )
 

·
Glockin’ since 1993
Joined
·
45,328 Posts
Technically the .380’s were only available to Law Enforcement but I’ve never seen one here in the USA.
I read that a number of Mexican agencies use(d) them.
I’ve read that it’s not just a barrel swap, there’s a number of .380 only parts.
 

·
Registered
Joined
·
313 Posts
Well 2 of my "Full Size " builds are Tac Sol 22LR rigs so I'm not hesitant to embrace anemic Calibers
22 excellent.

But unless you reload the 380 ACP like I did. If you buy factory ammunition to shoot. 380 ACP costs twice as much as 9mm and about the same as 40 S&W. As a reloader the 380 ACP is the same cost to the 9mm. For accuracy in the 380 ACP you have to load JHP as FMJ, plated RN and LRN have poor accuracy depending on your accuracy standards.
 
1 - 6 of 6 Posts
Top