Glock Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
52 Posts
Discussion Starter · #1 ·
Pulled some data on this and the min load was 7.2 according to one of my manuals (Speer I think). I wanted to start at 6.8 since the bullets are plated and I wanted to get that chrono'd too. so in working up the load I noticed that the case was very full, 75% maybe. Im working up to about 7.4 or 7.6 grns. I picked this powder because of the volume but now I'm a bit conceded of a compressed load. OAL is 1.12" so

Should I be concerned about this?
 

· Premium Member
Joined
·
285 Posts
Published data on using Unique tends to be a bit high. Berry's are plated and they state in their website to load to same levels as lead heads.

I run Berry's 180gr .40's over 5.6gr unique and make major out of my G35 with a lone wolf aftermarket barrel no problem.

Unique is a good all around powder.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top