Glock Firearms banner
ejector
1-5 of 5 Results
  1. Glock Forum
    Hello, So I am new to the Glock world and recently did a polymer80 G17 build. However I am having a problem. I used a Lone Wolf Distributors Frame completion kit, Part # LWDSPECTREFULLS on Brownells website, and I am not sure I have the right ejector installed because every time I fire the...
  2. Glock Forum
    I wanted to see if anyone else had a Glock 20SF and whether they ran into these issues below. I was able to find one forum from back in 2011 that someone started that mentioned them. When I picked up the 20SF, I looked under the slide and noticed there was 'wear' or a slight scratch to...
  3. Glock Forum
    Can anyone confirm there is a recall on most glocks to replace the Spring and the ejector assembly? :confused:
  4. Glock Forum
    So I, too, was experiencing ejection issues with target load ammo. I have a recently born Gen 3 with 1000 rounds through it (TTL***). Consistently, with Federal 115 grain FMJ, I was getting 1-2 BTFs every 10 rounds or so. So, with the information found here, I replaced my ejector. I found my...
  5. Glock Forum
    I sent it in because I was getting hit in the face with the spent casings. One even went down my wife's shirt and left a burn mark. But anyway it took them about 2 weeks to repair. The ejector was replaced with the new style one and they did fire it cause I sent it to them cleaned and could tell...
1-5 of 5 Results
Top