Glock Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. General Firearm Forum
    OK. Please don't judge. I learned my lesson. Anyway, so I was cleaning my AR BCG and was almost done when I decided to run a Tetra gun swab (pointy q-tip with a wooden stem) into the gas key to get some of the gunk out. It is a snug fit, but pretty good at getting out some of that gunk. The...
  2. Glock Forum
    Hi I am a fairly new gun owner and am experiencing my first malfunctions. First, off I have a used Glock 23 gen 3. It was firing great until I both made some mods and bought some reloaded "target quality" ammo. I put in a ZEV Technologies competition spring kit, a LANTAC SSR 3.5 lb connector...
  3. Glock Forum
    Hi everybody, yesterday I was cleaning my G45 after been to the range and I noticed that the original copper on the slide is gone, I can't see it anymore. The gun is pretty new (750 rounds) and I'm used to clean it everytime I go the range. Have I got to put some copper back on the slide? I...
  4. Gunsmithing
    Hello everybody I was cleaning my glock 43 today and noticed that the trigger piece that pushes up on the striker safety plunger is scratched on the side. Is this normal to get scratches there? I think it's from when I put the slide back on it it rubs agains a rail on the slide. Here is a pic of...
  5. Glock Forum
    As the title asks, I'm wondering if frequent detail cleaning is bad for a handgun? By detail cleaning I mean FULLY DISASSEMBLING the frame and slide to clean every single part. I bought my Glock 19 Gen4 back in July '12 and since then have put just over 1800 rounds through it, with no...
  6. Glock Forum
    Hey guys (and gals) I'm new to Glock forums (actually just logged in for the first time today) and i was just wondering what the best oil to use for my G23 would be. Any recommendations would be great. Thanks!
1-6 of 6 Results
Top