Glock Forum banner

New profile posts

· Premium Member
Joined
·
14,536 Posts
Danzig
PSa has a video discussing the Micro Dagger and it's magazines for use in Glocks,thought it maybe of interest.

  • Like
Reactions: Danzig

· Glockin’ since 1993
Joined
·
57,786 Posts
They supposedly debuted in January 2022 Shot Show but still haven’t been released. The slides and mags are available now.
I have a feeling Glock might have let them know there might be a lawsuit. Don’t know for sure but the frame is the easiest part to make.

· Registered
Joined
·
5 Posts
I am new to the site. I enjoy guns and currently own 5 Glocks. Retired in 2022 and I live 10 minutes from an Indoor Range, I enjoy shooting. I still would like to get a Model 23, Model 17, Model 21.

Model 19 - 9mm
Model 22 - 40 caliber
Model 42 - 380 acp
Model 43X - 9 mm
Model 45 - 9mm

I have several other pistols that are not Glock, like Colt, Smith and Wesson and Springfield.

· Registered
Joined
·
5 Posts
I just bought a G44 .22 today , and before I joined this group I’ve read that it jams up a lot depending on the ammo that’s being used. Is the G44 that bad of a gun? I haven’t shot it yet, I do have a glock 19 Gen5 and a Smith & Wesson MP 15-22 rifle, and I think I can use that ammo to the rifle on the G44….Any suggestions for the G44?

· Registered
Joined
·
1 Posts
Any idea where I can get a backstrap for my 43X. I have big hands. Thanks

· Registered
Joined
·
100 Posts
Email

wahrergriff at gmail

· Registered
Joined
·
17 Posts
The law in Florida allows concealed carry without a permit, but no open carry. Open carry is only allowed if you operate a store, e.t.c.

· Registered
Joined
·
0 Posts
Here's my settings:
Infill: 100%
Support: Everywhere, Grid
Overhang for support angle: 60%
Layer Height: 0.15 mm
Printing temp: 220 degrees
Bed Temp: 60 degrees
Filament: PLA+
Print Speed: 50 mm/s
Filament Speed: 50 mm/s

· Registered
Joined
·
0 Posts
Those are my first attempt at it, but had issues and didn't wasn't completed.
Here is the second attempt, and still currently running.

· Registered
Joined
·
0 Posts
The only reason I ask is because when I first tried printing a frame two days ago, it actually error'd out due to the filament being too tight wounded on the roll and my Ender 3 had issues pulling in the filament and continued to print dry. But when I removed what was printed from the bed and broke off all supports, the frame looks really rough. I included photos for you to check out.

· Registered
Joined
·
0 Posts
What's up TacticlSatan! Hey, so I just got into the 3d printing scene and currently printing my first p80 g17 frame....(actually printing it right now). Can I ask you what settings you use? Like if you use supports, and what kind? Raft? Infill?

· Registered
G48
Joined
·
3 Posts
I’m interested in the tyrant designs mag well and baseplate. It won’t let me write on the post

· Premium Member
Joined
·
4,356 Posts
Rev, I am not banned. But I have never had a G44. Maybe you messaged someone else?

· Registered
Joined
·
0 Posts
Retired LEO. Joined this forum way back in the beginning, couldn't find my original login.
Top